Home > single drum threaded pipe boiler

single drum threaded pipe boiler

About Us

Zozen Boiler main products include gas&oil boiler, coal-fired boiler, biomass boiler, thermal fluid heater and other series of more than 400 varieties of specifications.
Contact us for Email:[email protected]

Our Main Product

our main boilers
wns boiler picture

1-20 ton gas/oil fired boiler

Price: $12000-$450000/set

Capacity: 1-20 ton/h

Pressure: 0.7-2 Mpa

Fuel: Nature gas, coke oven gas, biogas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.

Industries: Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc.

szs boiler picture

7-70 MW gas/oil fired hot water boiler

Price: $160000-$1800000/set

Capacity: 7-70 MW

Pressure: 1.0-1.6 Mpa

Fuel: Nature gas, coke oven gas, blast furnace gas, carbon black off-gas, biogas, methanol, LPG, diesel, heavy oil, light oil, crude oil, etc.

Industries: Heat supplying, hospital, colleges and universities.

szl boiler picture

2.8-29mw coal fired boiler

Price: $70000-$750000/set

Capacity: 2.8-29mw

Pressure: 1.0-1.25 Mpa

Fuel: Bituminous coal, lean coal, anthracite

Industries: Heating, hotels, schools, hospitals

yyw boiler picture

horizontal thermal fluid heater

Price: $12000-$350000/set

Capacity: 700 - 14000 kw

Pressure: 0.8 - 1.0 Mpa

Fuel: natural gas, coke oven gas, bio-gas´╝îliquid propane gas, diesel, heavy oil, light oil, crude oil

Industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

dzl boiler picture

1-20 ton biomass fired boiler

Price: $12000-$350000/set

Capacity: 1-20 ton/h

Pressure: 0.7-2.5 Mpa

Fuel: Biomass particles

Industries: Heating, chemical, food, tobacco, textile, printing and dyeing, feed, medicine, building material, wine, rubber, hospital

650A/6500A Installation Manual (6500-IOM-3) - Westcast Boilers

PIPE. TAPPINGS FOR INDIRECT HEATERS. BOTH SIDES OF BOILER WHEN ORDERED .. Other nipples should be screwed into the drums as far as Note: Where one section is indicated in the table, two half sections are required since

451-IOM-3R - Westcast Boilers

one of the most critical operations in assembling this boiler, if it is not straight but allow adequate clearance for piping, service and mainten- ance. 4. CHIMNEY . Lift drum and thread nipples into front and rear sections. Tighten nipple into

DEPARTMENT OF LABOR CHAPTER 23

as close to the boiler shell or drum as is practicable, except when the boiler and less than one-third of the length of the tubes above the top of the furnace tube washout plugs of one-inch NPS which shall be screwed into openings in the

Attachment E-1b

Steam.Drum Internals. De$.uperheat.er. Internal Fe~d Lines. Dry Pipe. Continu~us Blow- Boiler Tubes. ~p~rheaters . One forced draft. .tza.n tor eeoh boiler .. f3elt driv-n by thumb screw for proper mixture of air and oil. The jacket tube

Troubleshooting boiler operation | Plant Engineering

Feb 15, 2012 One pump could not maintain boiler drum level and header pressure during sudden With the pointed end against the recirculation line pipe and the handle end against A tight threaded joint (using Teflon tape) is effective.

steam boiler, China steam boiler, steam boiler Manufacturers, steam

steam boiler is single-drum vertical/horizontal three-pass water boiler. Using the enhanced heat transfer internal thread pipe within the .

Model 4 Boiler Book - Cleaver-Brooks

the boiler, with connections to drain located on each side of the lower drum at the rear. . single burner boilers. . A. Connection is a Female Pipe Thread.

O-Type Specifications (doc) - Cleaver-Brooks

Saturated steam leaving the boiler steam drum shall not contain more than .5% The inboard row of finned tubes between the furnace and convection zone shall Membrane finned construction which utilizes a fin to tube weld on only one side .. Malleable iron fittings, 2 and under, aluminum body vent valve, threaded 2

PART 4 - CONSTRUCTION, INSTALLATION, ETC. - New York State

Subpart 4-5 Specific Requirements for Low Pressure Heating System Boilers Subpart 4-6 4-5.14 Water column and water level control pipes 4-5.15 Low water

Chapter SPS 341 (EXCERPTS FROM BOILER - Wisconsin.gov

(c) the first threaded joint in that type of connection; and which extends up to and .. PG58.3.1 The steam piping connected to the boiler drum or to the . purposes (when the boiler is under pressure) a single valve is acceptable, other-

F22B 11 - Steam boilers of combined fire-tube type and water-tube

/2014, CN103759241A Combined screwed pipe water-fire tube boiler double-purpose water-fire tube boiler with longitudinally configured single drum.

HEAT PIPE WASTE HEAT RECOVERY BOILERS - ScienceDirect

the stability of boiling in a drum, as in a fire tube boiler. . the heat pipes. The single point threaded attachment of the pipes to the pressure plate allows the

Boilers - Marine Engineering

In the early designs the drums were riveted or solid forged from a single ingot, but for . In water tube boilers roof and floor tubes are sloped at 15 to ensure circulation; thinner tube The smoke tubes may be plain or threaded to act as stays.

Attachment E-1b

Steam.Drum Internals. De$.uperheat.er. Internal Fe~d Lines. Dry Pipe. Continu~us Blow- Boiler Tubes. ~p~rheaters . One forced draft. .tza.n tor eeoh boiler .. f3elt driv-n by thumb screw for proper mixture of air and oil. The jacket tube

650A/6500A Installation Manual (6500-IOM-3) - Westcast Boilers

PIPE. TAPPINGS FOR INDIRECT HEATERS. BOTH SIDES OF BOILER WHEN ORDERED .. Other nipples should be screwed into the drums as far as Note: Where one section is indicated in the table, two half sections are required since

451-IOM-3R - Westcast Boilers

one of the most critical operations in assembling this boiler, if it is not straight but allow adequate clearance for piping, service and mainten- ance. 4. CHIMNEY . Lift drum and thread nipples into front and rear sections. Tighten nipple into

DEPARTMENT OF LABOR CHAPTER 23

as close to the boiler shell or drum as is practicable, except when the boiler and less than one-third of the length of the tubes above the top of the furnace tube washout plugs of one-inch NPS which shall be screwed into openings in the

Welding of Boilers, Pressure Vessels and Pressure Piping (Repealed)

any boiler or pressure vessel and includes piping as specified under section 8 . (b) On an annual retest if a pressure welder fails one coupon in one position . of welded fabrication with no threaded joints used and in no case shall a working.

GET Support & Price

Please Feel free to give your inquiry in the form below.We will reply you in 24 hours